![Tripp Lite SMART2200SLT Tripp Lite SMART2200SLT](https://cdn11.bigcommerce.com/s-b9xom8/images/stencil/190x250/products/17959/16734/smart2200slt__1__15450.1667477534.jpg?c=2)
![Tripp Lite SMART2200SLT Tripp Lite SMART2200SLT](https://cdn11.bigcommerce.com/s-b9xom8/images/stencil/190x250/products/17959/16734/smart2200slt__1__15450.1667477534.jpg?c=2)
Done shopping? You can create a PDF of your cart for later or for your purchasing dept! Details at checkout.
750VA UPS Smart Pro Tower Line-Interactive 8 outlet w/ SNMP Slot
OUTPUT | |
Output Volt Amp Capacity (VA) | 750 |
Output Watt Capacity (watts) | 500 |
Output power factor | 0.7 |
Nominal Output Voltage(s) Supported | 100V; 110V; 120V |
Nominal Voltage details | 120V default (voltage selection via back panel switches) |
Frequency compatibility | 50 / 60 Hz |
Output voltage regulation (line mode) | -13%, +15% |
Output voltage regulation (Battery mode) | +/- 5% |
Built-in UPS output receptacles | 8 5-15R outlet(s) |
Surge suppression only outlets | 4 UPS outlets, 4 surge-only outlets |
Output AC waveform (AC mode) | Sine wave |
Output AC waveform (battery mode) | Pure Sine wave |
INPUT | |
Rated input current (at maximum load) | 12A |
Nominal Input Voltage(s) Supported | 100V AC; 110V AC; 120V AC |
UPS input connection type | 5-15P |
UPS Input cord length (ft.) | 6 |
UPS Input cord length (m) | 1.8 |
Recommended Electrical Service | 15A 120V |
Phase | Single-Phase |
BATTERY | |
Full load runtime (minutes) | 6.5 min. (500w) |
Half load runtime (minutes) | 17.8 min. (250w) |
DC system voltage (VDC) | 24 |
Battery recharge rate (included batteries) | Less than 8 hours from 10% to 90% |
Replacement battery cartridge (internal UPS battery replacement) | RBC24-SLT |
Battery Access | Battery access door |
Battery replacement description | Hot-swappable, user replaceable batteries |
VOLTAGE REGULATION | |
Voltage regulation description | Automatic voltage regulation (AVR) maintains line power operation with an input voltage range of 83 to 145 (120v), 87 to 133 (110v), 83 to 121 (100v) |
Overvoltage correction | Voltage reduction of 12% applies when input is 127 to 145 (120v), 116 to 133 (110v), 106 to 121 (100v) |
Undervoltage correction | Voltage boost of 17% applies when input is 96 to 108 (120v), 87 to 99 (110v), 83 to 90 (100v) |
Severe undervoltage correction | Voltage boost of 32% applies when input is 83 to 95 (120v only) |
LEDS ALARMS & SWITCHES | |
LED Indicators | LEDs indicate line power, battery power, AVR, overload and replace battery status - with a 3-LED level meter for load and battery charge level |
Site wiring fault indication | Rear panel site wiring fault LED |
Alarms | Audible alarm indicates power failure and overload conditions |
Alarm cancel operation | Power-fail alarm can be silenced using alarm-cancel switch |
Switches | 2 Switches control off/on power status and alarm-cancel/self-test operation; rear panel protected switches support nominal voltage selection |
SURGE / NOISE SUPPRESSION | |
UPS AC suppression joule rating | 480 |
UPS AC suppression response time | Instantaneous |
UPS Dataline suppression | 1 line TEL/DSL (1 in / 1 out); 10/100Base T Ethernet |
EMI / RFI AC noise suppression | Yes |
PHYSICAL | |
Installation form factors supported with included accessories | Tower |
Primary form factor | Tower |
UPS / Power Module dimensions in primary form factor (height x width x depth / inches) | 10.2 x 6.8 x 13.25 |
UPS / Power Module dimensions in primary form factor (height x width x depth / cm) | 26 x 17.1 x 33.7 |
UPS / Power Module weight (lbs) | 30 |
UPS / Power Module weight (kg) | 13.6 |
UPS Shipping dimensions (height x width x depth / inches) | 13.8 x 9.8 x 13.2 |
UPS Shipping dimensions (height x width x depth / cm) | 34.9 x 24.8 x 33.7 |
Shipping weight (lbs) | 32 |
Shipping weight (kg) | 14.5 |
Cooling method | Fan |
UPS housing material | Steel |
ENVIRONMENTAL | |
Operating Temperature Range | +32 to +104 degrees Fahrenheit / 0 to +40 degrees Celsius |
Storage Temperature Range | +5 to +122 degrees Fahrenheit / -15 to +50 degrees Celsius |
Relative Humidity | 0 to 95%, non-condensing |
AC mode BTU / hr. (full load) | 7080% |
Battery mode BTU / hr. (full load) | 728.6 |
AC mode efficiency rating (100% load) | 96% |
Audible Noise | Audible Noise < 50 dBA at Front Side 1 Meter |
COMMUNICATIONS | |
Communications interface | USB; DB9 Serial; Slot for SNMP/Web interface |
Network monitoring port description | Supports detailed monitoring of UPS and site power conditions |
PowerAlert software | Included |
Communications cable | USB and DB9 cabling included |
WatchDog compatibility | Supports Watchdog application, OS and hard-reboot restart options for remote applications |
LINE / BATTERY TRANSFER | |
Transfer time | 4-8 milliseconds |
Low voltage transfer to battery power (setpoint) | 95V (120V), 87V (110V), 83V (100V) |
High voltage transfer to battery power (setpoint) | 145V (120V), 133V (110V), 121V (100V) |
SPECIAL FEATURES | |
Cold Start (startup in battery mode during a power failure) | Cold-start operation supported |
High availability UPS features | Hot swappable batteries |
Green & high efficiency features | Greater than 95% efficiency - GREEN UPS |
CERTIFICATIONS | |
UPS Certifications | Tested to UL1778 (USA); Tested to CSA (Canada); Tested to NOM (Mexico) |
UPS Certification details | EMI approvals: Yes |
WARRANTY | |
Product Warranty Period (Worldwide) | 2-year warranty, 3 year with registration. Note: Registration is required for 3-year warranty. |
Connected Equipment Insurance (U.S., Canada & Puerto Rico) | $250,000 Ultimate Lifetime Insurance |